CostKit

Container Loading Calculator

Ocean freight is priced per container, so "how many cartons fit" sets the logistics cost per piece. This tool tries all six orientations of a carton, keeps the one that packs the most, then checks the payload limit and reports the usable count and volume utilisation.

— cartons per container
Gross weight— kg
Cargo volume— m³
Volume utilisation— %
By volume / by payload— / — cartons

Nominal figures. Internal dimensions are typical published values — real containers vary by ±30 mm in width and door height depending on carrier and age. Packing is a clean grid, without pallets, dunnage or door clearance. Ask your forwarder to confirm against their own container list, especially for mixed or palletised loads.

Three numbers, three meanings

Formulas

by volume = ⌊L ÷ carton L⌋ × ⌊W ÷ carton W⌋ × ⌊H ÷ carton H⌋   (max of 6 orientations)
by payload = ⌊max payload ÷ carton gross weight⌋
usable     = min(by volume, by payload)
utilisation = cartons × carton volume ÷ container volume × 100%

Worked example

20GP (5898×2352×2393) with 600×400×400 cartons at 12 kg:

By volume: 9 × 5 × 5225 cartons
By payload: 28,200 ÷ 122,350 cartons
Usable225 cartons (volume-bound)
Gross weight2,700 kg
Utilisation (21.6 ÷ 33.2 m³)65.1%

65% is normal for cartons: a grid always leaves unusable wedges, and cartons bulge. The biggest gain is not a different container but a carton that matches the 2,352 mm internal width — a 392 mm carton fits six across exactly, 17% more width used than a 400 mm carton that only fits five.

Heavy versus bulky cargo

Multiply the volume-based count by the carton weight. If that exceeds payload, the cargo is heavy: the container fills by weight and stops early, so freight per piece rises. If not, it is bulky: the container is full but far below payload, and air freight would bill on volumetric weight. Changing container type often helps — 40HQ is 305 mm taller than 40GP, which is one extra layer for light cargo.

What the model ignores

FAQ

How much more does a 40HQ hold than a 40GP?

Same length and width, but 2,698 mm versus 2,393 mm internal height — 305 mm more. For 400 mm cartons that is usually one extra layer; for 600 mm cartons it may add nothing. Whether the high cube pays depends on whether your carton height divides into those 305 mm.

Why is my number lower than the forwarder's?

Three usual causes: the forwarder uses an empirical fill rate (about 85% for cartons) rather than a grid; they quote door dimensions as internal dimensions; or they assume palletised cargo. A gap under 10% is normal — beyond that, compare the exact container spec and orientation.

Should I stand cartons on end?

Sometimes it packs more, and the tool tries all six orientations. But standing a carton can violate "this side up" markings or load the weakest compression face. Maximum count is not maximum safety — fragile goods should follow the printed orientation.