Die Casting Cost Calculator
Die casting differs from injection molding in one important way: you pay for the shot, not the part. Runner metal, cycle time per shot and mold life in shots all drive the price.
Cycle — s · shot weight — g
Accuracy: ±30%. Cycle time depends heavily on the machine tonnage, die temperature control and spray routine. Thin walls and long flow paths push it up sharply.
Why die casting is priced per shot
- Runner metal — the biscuit, runners and overflow are cast every shot. They are remelted, but you pay for the melt energy and the loss. Typical runner ratios are 5–15% for small parts, more for thin-walled ones.
- Cycle time per shot, not per part — a 34-second cycle on a 2-cavity die gives 17 seconds of machine time per part. Adding cavities cuts machine cost per part almost linearly, but raises mold cost.
- Mold life in shots — die casting dies wear fast. Amortising a ¥300,000 die over 100,000 shots adds ¥3 per shot before yield loss, no matter how small the part is.
- Wall thickness — thick sections need longer solidification and hold time. A 6 mm wall can add ten seconds to the cycle versus 3 mm.
Formula
net_weight = volume × density
shot_per_part = net_weight × (1 + runner_ratio)
material = shot_per_part / 1000 × price_per_kg / (1 − scrap)
cycle_time = 20 + 3 × wall_mm + 0.5 × √volume
machine = cycle / 3600 / cavities × rate / (1 − scrap)
mold = mold_cost / life_shots / cavities / (1 − scrap)
total = material + machine + mold + deburring Worked example
ADC12, 100 cm³, 3 mm wall, 2 cavities, 5% scrap, 8% runner, ¥300k die over 100k shots:
| Net weight 270 g; shot 291.6 g → 306.9 g after scrap | — |
| Alloy at ¥19/kg | ¥5.83 |
| Cycle 34 s ÷ 2 cavities at ¥150/h | ¥0.75 |
| Mold ¥300,000 ÷ 100,000 shots ÷ 2 | ¥1.58 |
| Deburring | ¥1.50 |
| Total per part | ¥9.66 |
Alloy is 60% of the cost here. Switch the same part to ZAMAK 3 and the material line more than doubles, because zinc is 2.4× denser than aluminium and only 26% cheaper per kilo.
What this does not include
- Secondary machining — die cast parts usually need drilled, tapped or faced features
- Impregnation for pressure-tight parts
- Surface finishing (powder coating, painting, chromate)
- Die maintenance, repair and replacement of inserts within the quoted life
- Trial shots, first-article inspection, packaging and freight
FAQ
Die casting or gravity casting?
Die casting wins above roughly 3,000–5,000 parts per year, where the die cost amortises and the cycle advantage pays. Below that, gravity or sand casting with an inexpensive pattern is usually cheaper, and machining from billet may beat both.
How many cavities should the die have?
Fewer than you would think: two to four is typical. A die with many cavities costs more, takes longer to build, and is harder to keep balanced. Because die life is counted in shots, more cavities also means fewer shots per part — the amortisation benefit is smaller than for injection molding.
Why does my quote show a much higher scrap rate?
Thin walls, long flow paths, tight porosity requirements and cosmetic surfaces all push real scrap up. Suppliers often quote 5–10% for robust parts and 15–25% for difficult ones. Ask what rate they used — it moves the price more than the alloy price does.