Manual Machining Time Calculator
For one-off parts, repairs and prototypes, the job goes on a conventional lathe or mill, not a CNC. Removal rates are far lower, and setup time usually exceeds cutting time.
| Cutting time | — min |
| Setup time | — min |
| Total time | — min |
| Removal rate used | — cm³/min |
Accuracy: ±30%. Conventional machining depends on the operator as much as the machine. The removal rates below are mid-range values for sharp HSS or carbide tooling on a rigid machine.
Why setup usually costs more than cutting
- Removal rate — conventional machines remove 8–60 cm³/min depending on material. A CNC with modern tooling does several times that, which is why the CNC calculator uses a different model.
- Setup — clamping, indicating, finding edges. Five minutes a setup is optimistic for anything that needs alignment; 15 minutes is common for repair work.
- Auxiliary time — measuring, changing tools, clearing chips. On a one-off part this is not a rounding error, it is a third of the job.
Removal rates used (cm³/min)
| Operation | Steel | Stainless | Alu | Brass | Cast iron |
|---|---|---|---|---|---|
| Turning | 25 | 8 | 60 | 45 | 20 |
| Milling | 15 | 6 | 45 | 35 | 12 |
| Drilling | 10 | 4 | 30 | 25 | 8 |
| Surface grinding | 2 | 1 | 5 | 4 | 2 |
Formula
cutting_min = removal_cm3 / removal_rate
setup_min = setups × minutes_per_setup
total_min = cutting_min + setup_min + aux_min
cost = total_min / 60 × rate_per_hour Worked example
Aluminium turned part, 120 cm³ removed, 2 setups of 5 min, 3 min auxiliary, ¥80/hour:
| Cutting: 120 ÷ 60 | 2.0 min |
| Setups: 2 × 5 | 10.0 min |
| Auxiliary | 3.0 min |
| Total | 15.0 min |
| Cost at ¥80/h | ¥20.00 |
Cutting is 13% of the time. Making the same part from stainless multiplies cutting by 7.5 to 15 minutes — but setups and auxiliary stay the same, so the total only rises from 15 to 28 minutes. On small jobs, material choice matters less than people assume.
What this does not include
- Material cost — see the CNC machining calculator for stock and tooling
- Fixture or soft-jaw fabrication
- Inspection, deburring, surface treatment
- Waiting, transport between operations, rework
- Programming — there is none on a manual machine, which is its advantage for one-offs
FAQ
When is manual cheaper than CNC?
For quantities under about 10 pieces, and for anything that needs to be measured and adjusted as you go — repairs, fitting, one-off fixtures. The breakeven is roughly the time to write and prove a CNC program, which for a simple part is 30–60 minutes.
Why is stainless so much slower?
It work-hardens, conducts heat poorly and demands lower surface speeds with more coolant. Removal rates drop by three to five times versus mild steel, and tool wear is far higher. If a design can use 304 instead of 316, it is usually worth it.
How do I estimate removal volume?
Take the stock envelope minus the finished part volume for roughing, then add features separately. A 50 mm bar turned down to 40 mm over 100 mm length removes about 70 cm³. For a quick sanity check, weigh the chips if you have made the part before.