Packaging Cost Calculator
Packaging is priced by blank area, colour count and batch. The die is the number people forget — on a 500-piece run it can cost more than the cardboard.
Blank area — m²
Accuracy: ±25%. Real quotes depend on board grade, sheet utilisation and whether the printer is running your job as a fill-in or as a dedicated run.
What actually determines the price
- Blank area — the flat sheet before folding, not the finished box size. A 200 × 150 × 100 mm carton needs roughly 0.25 m² of board, not 0.03 m².
- Colour count — each colour adds a plate and a pass. Four colours is standard; adding a fifth for a spot colour often costs 20–30% more on printing.
- Die cost — a one-time cutting die. ¥800 is cheap; a blister mould at ¥5,000 is not. Both are amortised over the batch, which is why small runs look expensive.
- Forming labour — folding, gluing and inserting. Small folding cartons run through a folder-gluer; odd shapes are hand-folded and cost several times more.
Formula
area_m2 = area_cm2 / 10,000
material = area_m2 × price_per_m2
printing = area_m2 × colours × price_per_colour_m2
die = die_cost / batch_size
labour = forming_minutes / 60 × labour_rate
total = material + printing + die + labour + extras Worked example
Printed folding carton, 800 cm² blank, 4 colours, batch of 5,000:
| Board: 0.08 m² × ¥3.50 | ¥0.28 |
| Printing: 0.08 × 4 × ¥0.80 | ¥0.26 |
| Die: ¥800 ÷ 5,000 | ¥0.16 |
| Folding 0.3 min @ ¥30/h | ¥0.15 |
| Total per unit | ¥0.85 |
At 500 pieces instead of 5,000 the die alone becomes ¥1.60 per box — nearly double the whole unit cost. This is why packaging suppliers push you toward standard sizes: a stock box with no die has no amortisation to carry.
What this does not include
- Sheet utilisation loss (typically 10–25% of board is trimmed away)
- Special finishes: foil stamping, embossing, UV varnish, soft-touch lamination
- Proofs, colour matching and pre-production samples
- Master cartons, pallets, stretch wrap and shipping
- Storage and minimum order quantities
FAQ
How do I calculate blank area?
Ask your packaging supplier for the dieline — it is the flat drawing with exact dimensions. Estimating from the finished box size underestimates badly, because the blank includes flaps, glue tabs and the sides. If you have no dieline, add roughly 40% to the surface area of the assembled box.
Is it cheaper to use a stock box?
Almost always, below about 2,000 units. A stock size has no die cost and no setup, so even at a higher unit price it wins. Custom printing on a stock box is the usual compromise: you pay for plates but not for a die.
Why is my blister quote so much higher than the carton?
Two reasons: the forming mould is several thousand yuan, and blisters usually need a printed backing card as well. On runs below 10,000 the mould dominates. Above that, the material and the sealing step become the main lines.