3D Printing Cost Calculator
Estimate the per-part cost of an FDM print: filament, machine time, energy, post-processing and labour, with failed prints costed in. Use it to check a print-service quote or to price your own parts.
Material used — g · print time — h
Accuracy: ±30%. Slicer settings, nozzle temperature, printer model and part orientation change real print time a lot. This model gives the structure and order of magnitude; for an exact figure, slice the part and use the printer's reported time.
What drives 3D print cost
- Print time — usually the largest line for solid or tall parts. Time scales with volume divided by flow rate, so halving the layer height roughly doubles it.
- Infill — 20% is standard. Going to 60% for strength adds material and time without changing the outside dimensions.
- Supports — overhangs need material that you pay for and then remove. Designing them out saves more than any setting.
- Failure rate — a failed print wastes both material and machine time. A 3% rate adds 3%; a 30% rate (typical on first prints of new designs) adds 43%.
Formula
effective_volume = model × (0.2 + 0.8 × infill)
print_volume = effective_volume + model × support_ratio
grams = print_volume × density
filament_cost = grams / 1000 × price_per_kg / (1 − failure_rate)
flow_rate = 15 cm³/h × (layer_height / 0.2)
print_hours = print_volume / flow_rate × 1.1
machine_cost = print_hours × machine_rate / (1 − failure_rate)
energy_cost = print_hours × energy_rate / (1 − failure_rate)
labour = handling_minutes / 60 × labour_rate
total = filament + machine + energy + post + labour Worked example
PLA, 50 cm³ model, 20% infill, 10% supports, 0.2 mm layers, 3% failure:
| Material used: 23 cm³ × 1.24 = 28.5 g | — |
| Filament (¥90/kg, failure-adjusted) | ¥2.65 |
| Print time 1.69 h × ¥15/h (failure-adjusted) | ¥26.08 |
| Energy 1.69 h × ¥0.5/h | ¥0.87 |
| Post-processing | ¥2.00 |
| Handling 3 min @ ¥40/h | ¥2.00 |
| Total per part | ¥33.60 |
Here machine time is almost 80% of the cost. Halving the print time (larger layers, less infill, a smaller part) matters far more than cheaper filament.
What this does not include
- CAD design and modelling time
- Printer depreciation beyond the hourly rate you enter
- Packaging, shipping, and taxes
- Multi-colour or multi-material printing
- Profit margin and overhead allocation
FAQ
Why is a print-service quote so much higher than this?
Services add setup time, minimum order fees, slicing and review labour, profit margin and often a rush surcharge. Compare the material and print-time lines first; if they match, the difference is their overhead.
Does PLA or PETG cost more per part?
Usually PETG, because the filament price is higher and the print needs a slower speed. For most prototypes the difference is a few yuan per part. Pick by material performance, not cost.
How accurate is the time estimate?
It is a volume-flow approximation with a 10% allowance for travel and retraction. It tends to be within ±30% of the slicer's reported time for simple parts. Thin walls and small features are where it underestimates most.